- Cut out all the extra parts of the picture
(all four sides) into the required size.
- Attach the picture sheet into the shifting
layer of the frame with a double sided
adhesive tape. ¡@¡@Then, put the shifting
layer back into the frame.
- Button up the rotor wheel at the bottom
of the frame. Reset the shifting layer
properly by
placing the locator pins at the top and
bottom.
- Put the overlay lenticular len on the
frame, making sure to cover the lenticular
len with its smooth side facing inwards
and the grained side facing outwards.
- Put the photo frame front panel cover
back on.
- Check to see if everything is alright.
If so, insert one AA (UM-3) dry cell battery.
- Install the back bracket while the
frame is flat on the table. Use the fine
leveling control on the ¡@¡@back of the
frame to align the picture to the lenticular
len. This would help achieve the maximum¡@
effect of the morphing images.
- Regulate the speed of the morphing
images transition by turning the knob
at the bottom of the ¡@frame; turning it
clockwise "S"
to slows down the transition, while turning
it anticlockwise "F"
to ¡@accelerates it.
- The entire MPF installation and adjusting
process is now completed.
|
